"FUZZY" control system
Most admirable man machine interface.Easy to Learn, easy to operate.
A Mew starter can do a good job only in 5 minutes. No more headache for learning.
 
100 Sets machining condition memories : Can store 100 sets user machining condition.
"Fuzzy" control circuits : Only input (A) Machining materials, (B) Electrode diameter, (C) Electrode wear. New starter learns how to operate on in 5 minutes.
Electrode will automatically retract to home point when arriving depth, greatly reduce moving time.
Z axies coordinate will automatically set to zero when finding edge.
" Off time " will be adjusted when machining is not stable, if unstable situation over a certain time, sparking will be stopped.
Special high pressure pump design, water come out quickly and with pressure releasing control system in order to reverse water without any dropping.
Machining parameters can be modified temporarily while machining, without affecting the stored parameter.
 
1.
100 sets machining condition memouries : Can store 100 sets user machining condition.
2.
6 kinds machining parameters : includes peak curent, capacitor, on time, off time, spearking gap, and Servo sensitivy.
3.
Fuction of choosing " Fuzzy" machining condition : through (a) Machining materials, (b)Electrode diameter, (c) Electrode wear, to chose the best machining conditions.
4.
Includes 3 axes DRO system : X, Y axes use linear scale, Z axis uses encoder.
5.
Five kinds of alarm indicators : will be lighten when depth arrival, arcing, low dielectric level, for safety, and a short on electrode and workpiece.
6.
Anti-hitting system for electrode.
7.
Electrode will automatically retract when retract when arriving depth : Thriogh DRO counter to set home point, electrode will automatically retract to home point, electrode wear, and machining depth. The bottom of electrode will automatically retract to home point when arriving depth.
8.
Using " MOSFET" sparking circuits, suitable for slanting, carbide, hard alloys, hard steel, and powder metallurgical.
9.
Electrode renge from 0.2 to 3.0 m/m, apply to slanting, spherical, and curved wokpieces machining.
10.
Arcing protecting circuits:automatically adjust "off time" when maching is not stable. If arcing over certain time,sparking will be automatically stopped.
11.
Special high pressure pump design, water come out quickly and with pressure releasing control system in order to reverse water without any dropping.
12.
Machining paramters can be modified timporarily while sparking, without affecting the stored parameters.
 

MODEL
JM528DZ
ITEM
Work table size

600 x 300 mm

X, Y travel
350 x 220 mm
Z Ram servo travel
345 mm
W axis
200 mm
Guide travel

150 mm

Max, workpiece weight
450 kgs
Electrode
0.2 mm-3.0 mm
Max. electrode length
400 mm
Ram platen to worktable
5-355 mm
Capacity weight
10 L x 2
Machine weight
900 kgs
machine dimension
1090 x 1545 x 2070 mm
*All specification and design subject to change without notices.
 

MODEL
JM528DZ
ITEM
Power input

220/220/364/380/440/575/600/ 3phase VAC
Max. power consumption
5 KVA
Max. peak current
38A
Sparking condition number
100 set (0~99)
Peak current setting

15 steps (0.3A~38A)
Capacitor setting
16 steps (0~15)
On time setting
99 steps (1~99)
Off time setting
99 steps (1~99)
Sparking gap setting
16 steps (1~16)
Servo sensitivity setting
100 steps (0~99)